Repair Service - Rowenta SILENCE FORCE MULTI-CYCLONIC Guia Del Usuario

101286_VACUUM_SAFETY.qxp_101286 25/01/2016 11:25 Page6
Instructions regarding the energy label
This is a general purpose vacuum cleaner.
To achieve energy efficiency and the cleaning performance category indicated on carpets, please use the dual
position vacuum head, with the brush retracted (
To achieve energy efficiency and cleaning performance category indicated on hard floors with joints and grooves,
please either use :
• The nozzle for smooth floors with grooves* (a) without the removable brush.
• The dual position vacuum head*, with the brush retracted (
The data provided relating to the energy label was established using the measuring
methods defined in the Directives 665/2013 of 3 May 2013 and 666/2013 of 8 July
2013.
For delicate smooth floorings, such as parquet, laminated flooring or tiles, it is recommended to use either :
• The nozzle for smooth floors with grooves*, with the brush retracted (a+b).
• The dual position vacuum head*, with the brush extended (

REPAIR SERVICE

IMPORTANT : If you notice that your vacuum cleaner is not operating as well, before car-
rying out any checks, switch it off using the ON/OFF pedal.
Repairs should only be performed by specialists using original spare parts.
If a problem persists, take your vacuum cleaner to your nearest Approved Service Centre or contact Customer Services.
If your vacuum cleaner does not function :
• Check that the appliance is plugged in correctly.
If the suction attachment is difficult to move :
• Reduce the power by opening the mechanical power control on the butt or by moving the electronic power
control switch towards the MIN position.
• Make sure that the position of the nozzle corresponds to the floor being vacuumed :
- for rugs and carpets, use the nozzle in the retracted brush position,
- for parquets and smooth floors, use the nozzle in the advanced position.
If the power cord does not wind up completely :
• The power cord is slow to wind up: pull the cord out again and press on the power cord rewind pedal.
If your vacuum cleaner stops during use :
• The safety mechanism was triggered. Check the tube and hose for blockage. Check if the bag and filters are sa-
turated. Leave 30 minutes to cool down before switching the vacuum cleaner on again.
Vacuum cleaners with bag
If your vacuum cleaner suction is not working properly or is making a whistling noise :
• There is a partial blockage in an accessory or in the hose: unblock the accessory or hose.
• The bag is full or saturated with fine dust: replace the bag* or empty the textile bag*.
• The lid is not properly closed: check the placement of the bag, of the dust bag holder and of the EPA filter casket
and close the lid.
• The filters are saturated: clean or change the filtration system EPA casket*, washable EPA filter casket*, microfilter
casket*. See supplementary instruction manual).
If the change bag warning light is red :
• The bag is saturated: replace the bag or empty the textile bag*.
• If the warning light remains red after the bag has been replaced: the filtration system is saturated (see supple-
mentary instruction manual)
If the lid does not close :
• Check to see if there is a bag and a dust bag holder in place and make sure they are well positioned.
• Make sure that the EPA filter* casket or the microfilter* casket is well positioned.
* Model dependent: these parts are specific to certain models or they are accessories that can be purchased separately.
*).
*).
*).
EN
*
a
b
6