Using The Power Inverter; Dc Power Port - GENMAC OTTO Manual De Usuario

any AC appliance not in use� there is a user replaceable 40 amp automotive type fuse below
the Inverter power switch� this fuse protects the inverter from an unlikely excessive input cur-
rent� ordinary overloads will cause the inverter to automatically shut down� Reduce the load
and restart the inverter�

UsInG tHe poWeR InVeRteR

1� open the AC outlet dust cover�
2� Connect the AC appliance or appliances to either AC outlet�
3� turn the Inverter on by flipping the switch to the "||" position�
4� If the Inverter power Indicator light is green, the inverter is operating�
5� turn on one AC appliance and observe the power Indicator�
• If the leD remains green, then turn on the second appliance�
• If the power Indicator remains green, then both appliances are
operating properly�
• After use, remove the appliance plug and close the dust cover�
• If the power indicator leD is not lit, then reduce the AC load�
If the inverter is still not operating, refer to the troubleshooting
table at the end of this User's Manual�
• Recharge otto 8 in 1 emergency Kit as soon as convenient�
note:
• "|" = turns on UsB ports and DC outlets
• "o" = off
• "||" = turns on AC Inverter, UsB ports, and DC outlets
Caution
some rechargeable devices are equipped with a separate AC charger� these devices are
likely to operate properly with this inverter� Rechargeable devices that have built-in chargers
(see device owner's manual) may not operate properly with this type of inverter�
some motorized devices may operate at excessively elevated temperature when used with this
inverter� During first use with this inverter, check for excessive motor temperature� Abnormally
elevated temperature of the device is an indication that they should not be used together�

DC poWeR poRt

DC power port (accessory socket) is located to the left of the Battery status meter (voltmeter)�
the port can power a DC load up to 11 Amps� overloading the port will result in tripping (a
self-resetting circuit breaker)� Removing the overload automatically
restores power to the DC power port�
1� Uncover the dust cover from the power port�
2� Insert the 12V DC accessory plug into the power port�
3� operate the appliance as usual�
User's Manual—Read before using this equipment
11