Jumpstarting; Work Light - GENMAC OTTO Manual De Usuario

jUMpstARtInG

1� Review the jump start Warnings�
2� Make sure all vehicle appliances, lights, radio, etc are turned off�
3� Make sure the vehicle's gear is in "park" position and the brake is set�
4� Make sure all otto 8 in 1 emergency Kit switches are off�
5� securely connect the red (+) cable clamp to the vehicle's positive (+) battery terminal�
6� Connect the black (−) cable clamp to a non-moving part on the vehicle�
7� observe the color of the Reverse polarity protection Indicator that is located between the
Battery status button and Work light switch�
• If the light is ReD, Do not tURn on tHe jUMpeR sAfetY sWItCH!
i� Cable clamps need to be reversed�
ii� Disconnect the black clamp first then the red clamp�
iii� Reconnect and observe the indicator again�
• If the light is GReen, turn on the jumper safety switch�
i� Inside the vehicle, turn on the ignition switch and attempt to start the engine�
ii� Crank a maximum of three seconds� If the engine does not start, wait three
minutes before the next attempt�
iii� After the engine starts, turn off the jumper safety switch�
iv� Disconnect the black clamp first, and then disconnect the red clamp�
8� Be sure that the cables and clamps are securely stored�
9� Recharge the otto 8 in 1 emergency Kit as soon as convenient�
note: If the engine does not start, there may be a problem other than a discharged battery�
Call for service�

WoRK lIGHt

the Work light is a cluster of bright leDs located above the negative jumper Cable
storage area� the location of the Work light allows the light to be used while the
otto 8 in 1 emergency Kit is being carried�
• turn the work light switch (located on front panel) to the "I" position for power on�
• the light will illuminate�
• turn off while not in use�
User's Manual—Read before using this equipment
15