Craftsman CMXZSAJ94793 Manual De Instructiones página 6

English
Workshop Table and Stool Set
CMXZSAJ94793
IMPORTANT SAFETY INFORMATION

WARNING:
INJURY, USER MUST READ THIS INSTRUCTION
MANUAL BEFORE OPERATING PRODUCT.
a ) Read, study, understand and follow all
instructions before assembling or operating
this device.
b ) Do not stand on the table.
c ) Weight capacity and other product capabilities
apply to properly and completely assembled
product only.
d ) The warnings, cautions, and instructions in this
manual cannot cover all possible conditions or
situations that could occur. Exercise common sense
and caution when using this stool. Always be aware
of the environment and ensure that the stool is used
in a safe and responsible manner.
e ) Do not modify this table in any way.
Unauthorized modification may impair the function
and/or safety and could affect the life of the product.
There are specific applications for which the product
was designed.
f ) Use the right tool for the job. DO NOT attempt
to force small equipment to do the work of larger
industrial equipment. There are certain applications
for which this equipment was designed. It will be
safer and do a better job at the capacity for which
it was intended. DO NOT use this equipment for a
purpose for which it was not intended.
SAVE ALL WARNINGS
AND INSTRUCTIONS FOR
FUTURE REFERENCE
TABLE SPECIFICATIONS
Width
Height
Depth
Weight
Capacity
Table Top Diameter
6
TO REDUCE THE RISK OF
23.62" (600.0 mm)
38.97" (990.0 mm)
23.62" (600.0 mm)
18.4 lbs. (8.3 kg)
30 lbs. (13.6 kg)
23.62" (600.0 mm)
READ ALL INSTRUCTIONS
ASSEMBLY

Before assembling table, make sure all parts are
present. Compare parts with contents list. If any
part is missing or damaged, do not attempt to
assemble, install, or operate the product.
Contact customer service for replacement parts.
Table Assembly (Fig. F-L)
1. Place the base trim bracket
2. Insert the table top post
3. Using the base bolt - M6 x 35 mm
mounting bracket 8
the bottom of the base assembly. Tighten the base bolt
M6 x 35 mm until snug. (Fig H)
4. Take the foot rest 4 and orient it so the ring is up. Slide
the foot rest ring onto the table top post
rest can be positioned anywhere on the table top post.
The foot rest is secured to the table top post by using
the foot rest bolt - M6 x 12 mm
5. Place the table top mounting bracket
the table top post 3 . The table top mounting bracket
has a specific orientation to be installed properly. The
flat face of the table top mounting bracket should be on
top. Using two (2) of the bolt - M6 x 14 mm
the table top mounting bracket onto the table top
post. (Fig J)
6. Place the table top 1
bracket 2 . Line up the holes and start threading in the
remaining four screws - M6 x 14 mm
the bottom side of the table top mounting bracket.
Once all four (4) screws have been started, they can be
tightened down in a criss-cross pattern to secure the
table top to the table top mounting bracket.
7. Remove the protective file that has been applied to
the table top 1 .
8. Adjust the feet 11 on the bottom of the workshop table
base 7 to level the table to the ground. (Fig L)
Fig. F
7
6 onto the base 7
3 into the base bracket.
9 , secure the base
onto the table top post 3
3 . The foot
5 . (Fig I)
2 onto the top of
10
on top of the table top mounting
10 by hand from
(Fig K)
. (Fig F)
(Fig G)
, from
, secure
6