Assembly & Set-Up; Important - Troy-Bilt FLEX Manual Del Operador

Assembly & Set-Up
Assembly
Installing the Discharge Chute
A discharge chute, wire spring, and chute band,
have been included with this attachment. Please
assemble them now by installing the discharge chute
onto the snow thrower by following these steps:
1. Install the wire spring into the discharge
opening of the snow thrower by inserting
both ends into the slots provided. See Figure
3-1 for proper location and orientation of
the spring. The inset of Figure 3-1 shows the
spring properly installed with the ends fitted
into the slots provided.
NOTE: Place some of the white lithium grease
provided on the wire spring and chute
adapter ring prior to assembly as shown in
Figure 3-1.
Figure 3-1
2. Install the discharge chute, packed loose in the
carton, onto the snow thrower attachment, as
shown in Figure 3-2.
Figure 3-2
NOTE: Position the discharge chute at an
angle to the right for ease of installation.
IMPORTANT: Apply white lithium grease
(included with this attachment) onto the chute
ring, chute spring, and chute adapter ring
prior to assembly.
6
3. Clip the discharge chute handle onto the
discharge chute, as shown in Figure 3-3.
Figure 3-3
4. Place some of the white lithium grease
provided on the chute band as shown in
Figure 3-4.
Figure 3-4
5. Install the chute band as shown in Figure 3-5.
Figure 3-5
6. With the discharge chute positioned to the
right as shown, install the chute band by lining
up the notches in the front with the band, and
making certain to fit the discharge chute inside
the channel of the chute band, as detailed in
the inset of Figure 3-6.
Figure 3-6
7. Secure the chute band to itself by first aligning
the two snap-fit features and pushing the
two ends (1 & 2) together as shown. Be sure
both tabs on the two ends engage each other,
as shown in the top left inset of Figure 3-7.
When properly assembled, the chute band will
appear as in the top right inset of Figure 3-7.
2
Figure 3-7
IMPORTANT! If you need to remove the chute for any
reason, a screw driver must be used to release the
locking tabs shown above in the left inset of Figure
3-7.
3
1