All manuals and user guides at all-guides.com
GB
7- Harness release button
8- Harness adjuster
9- Shoulder pads (x) forward facing use only.
10- Diagonal belt guides (x) for rearward facing use only
11- Red belt lock-off (x) for diagonal belt (forward facing use only)
12- Lap belt guides (x) for forward facing use only
13- Lap belt guides (x) for rearward facing use only
14- Blue lock-off clip for rearward facing use only.
I FITTING YOUR CHILD SEAT INTO YOUR CAR
2 Rearward facing (0 - 10 kg)
When used rearward facing,the child seat must be in the fully reclined position. Pull
lap and diagonal sections of the car seat belt until fully extended and feed both
through the space between the shell and the base.Fasten the seat belt.
1- Thread the lap section through the guides located at the front of the base (blue
arrows)
2- Thread the diagonal strap through the two upper guides located on the back of
the seat shell.
3- Tighten the seat belt by pulling first on the lap section,then on the diagonal one.
4- Check that there are no kinks or twists in the seat belt.Lock the sections of
the belt with the blue lock-off clip.The lock-off should be positionned against
the buckle of the seat belt.Do not use the red lock-off for the rearward facing
installation.Always keep the seat in the most reclined position.
3 Forward facing (9-18kg)
1- Fully recline the seat.Pull lap and diagonal sections of the car seat belt until fully
extended and feed both through the space between the shell and the base.Fasten
the seat belt.
2- Thread the lap section through the guides located below the red lock-off clips.
Open the red lock-off clip next to the buckle,then route the diagonal section of the
belt through the open lock-off clip.
3- Push the child seat right down into the car seat,and tighten both sections of the
seat belt by pulling the belt in the direction shown.
4- Close the lock-off across the diagonal belt.Check that there are no kinks or twists
in the seat belt.
II INSTALLING YOUR CHILD IN THE CAR SEAT
4 Harness : the buckle
5 Adjusting the harness
1- Adjust the shoulder height of the harness in one of the three positions,so that
1