A: Landscape, -20° leaning
Step 1:
Checking the parts
required for the
installation
Follow Step 1 in the SU-WL500 instruction manual to
check the parts.
Step 2:
Deciding on the
installation location
Follow Step 2 in the SU-WL500 instruction manual to
decide on the installation location. Refer to page 26
of this manual for the LCD Display installation
dimension table.
Step 3:
Installing the Base
Bracket on the wall
Follow Step 3 in the SU-WL500 instruction manual to
install the Base Bracket.
10
(US)
Step 4:
Preparing for the
installation of the LCD
Display
1
Remove the screws from the
rear of the LCD Display.
Note
• Be sure to store the removed screws in a safe place,
keeping them away from children. When attaching
the stands to the LCD Display again, be sure to
install the stored screws back in the original
position.
When using an electric screwdriver, set the torque
setting to approximately 1.5 N·m {15 kgf·cm}.
Do not lift the Mounting Hook before the screws
(two screws each for left/right) are secured. This
may distort the Mounting Hook or the LCD Display
cabinet.