Product Operation; Safety Lock; Cutting Guide - Marshalltown BULLET ES90-0126 Manual Del Usuario

When most materials are cut, the 'drop' piece will have a beveled edge, while the 'keep' piece (the piece left on
the table) will have a mostly square edge.
1. While gently pushing handle
down, pull Safety Lock pin out,
then lift handle.
When not in use, slide the Safety Lock pin into the Power Assembly to lock your tool. To remove, gently push the
handle down, pull out the Safety Lock pin, then lift the handle.
Always re-engage the Safety Lock pin and secure the extended handle in the down position while storing,
carrying, or transporting your shear.
The EZ Shear Flooring Shear is designed to cut a variety of materials. Materials include Engineered Hardwood
Flooring (up to 5/8"/15mm thick and 1250 Janka), Laminate Flooring, LVT, LVP, VCT, PVC & Rubber Tile, Cove
Base, WPC, SPC, MLF, and Rigid Core.
Note: DO NOT attempt to cut any solid wood, high-pressure laminate, or engineered hardwood with a
Janka Hardness Rating higher than 1250.
Note: Even the approved materials may vary greatly in density and hardness. If extreme force is required to cut
a material stop immediately, as it could lead to damage to your shear or injury. Attempting to cut unapproved
materials will void the warranty.
WS2648
104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.MARSHALLTOWN.com

PRODUCT OPERATION

2. Place product on table. It is
recommended that you HOLD
YOUR MATERIAL IN PLACE
until the cut is complete.
Bring handle down until blade
touches material.

SAFETY LOCK

TRANSPORT

CUTTING GUIDE

3. Push handle down to cut.
Some effort may be required
depending of hardness of
material.
7 of 16