OHAUS ACHIEVER e-A51ST020 Guia Del Usuario página 6

EN-4
Gear (only for
e-A51ST200)
Torque
Lock
4. Menu
Hold the control knob (F) for 3 seconds to enter into the setting mode when stirring
is off. Turning the control knob (F) it is possible to pass from one of the following
parameters to the next one. Click the knob to modify
Parameter
shown on
display
NOdE
LINt
e-A51ST200
e-A51ST100
e-A51ST060
e-A51ST040
e-A51ST020
COun
UPGr
rSEt
CAl
Set the operating speed range by clicking Gear button (D).

 The gear set has its relative LED (C or E) lighted on.
It's possible to select between two gears:

-
Gear 1: Low speed (6 – 400 rpm) High torque (till 200 Ncm).
-
Gear 2: High speed (30 – 2000 rpm) Low torque (till 40 Ncm).
The torque indicator bar (B), made by four LEDs, shows the intensity of

the torque applied
Holding the Lock key (H) for 3 seconds it's possible to lock the control

panel.
 Unlock the control panel by holding key H for 3 seconds.
When the instrument is locked,

-
LED (I) lights on for e-A51ST200
-
LED (G) and (I) light on for other models
Default value
StOP
400 (1)
2000 (2)
1300
2000
2000
2000
nO
nO
ACHIEVER
Range
Set starting mode:

StOP -
run

100 - 400 Set the maximum value of speed
set point.
100 - 2000
100 - 1300
100 - 2000
100 - 2000
100 - 2000
Running time in H. If "." is showed
before the number, the running
time is in Day.
To install a new software version
To restore default setting
YES - nO
parameters
YES - nO
To reset torque zero value
TM Overhead Stirrers
Description
Stop: when the instrument is
switched on through the
main switch, OFF is
displayed.
Run: when the instrument is
switched on, it restarts to
work with the last set points.