Running A Ramp Program - Thermo Scientific ADVANCED Serie Manual Del Usuario

Running a Ramp Program

1. Use the arrows to highlight
press .
SP1
20.00°C
24.29 °C
3. Press and the circulator displays the start
and pause/resume
light the start symbol
Ramp
20.00°C
24.29 °C
Start program
Stop program and shut down circulator
Pause program, press
Current Cycle: Current Step:
Total Program Time Remaining (Minutes)
2 4 . 2 C
If a program is not running, highlighting
ture to go to the ramp
Thermo Scientific
SP
window and
Menu
In
program symbols. High-
.
Menu
In
to restart
Water
1:1:180
Ramp
Start Temp
. The temperature remains there until the ramp is started.
2. Press the up or down arrow until the win-
Ramp
dow displays
Ramp
20.00°C
4. With the start symbol highlighted, press
start the program. The start symbol changes into
a highlighted stop program symbol
Note With the stop symbol
pressing shuts down the circulator.
The program does not start until the process fluid
temperature is at the
Variance
the .
Ramp
20.00°C
Switching to the Status Display while a ramp
program is running shows the status and program
time remaining. Note If assured soak is enabled
the time stops counting down at the end of the
step until the desired temperature ± variance is
reached.

with the circulator running causes the bath tempera-
Section 4 Operation
.
Menu
In
24.29 °C
.
highlighted,

Step 1 Start Temp
Menu
In
24.29 °C
to
±
4-49