Style selections SSR3472CLSV Manual Del Usuario página 5

ASSEMBLY INSTRUCTIONS
Note: Instructions show right-side installation. Reverse for left-side installation. Instructions include
parts that are packed with Frameless Door (Item #095412, 0954410, sold separately).
1. Set fixed panel jamb (A) on shower base
threshold. Use a level to ensure panel jamb (A)
is level. Using a pencil (not included), mark the
four pre-drilled hole locations. Remove panel
jamb (A). Using a drill (not included), drill holes
approximately 1-1/2 in. deep into each marking.
NOTE: If installing into tile, use 1/4 in. masonry
bit (not included) and proceed to step 2a. If
installing into an acrylic or fiberglass shower
enclosure, use 1/8 in. drill bit (not included) and
proceed to step 2b.
2a. Tile installation: Insert wall anchors (CC) into
each drilled hole using rubber mallet (not
included). Place fixed panel jamb (A) back into
place. Tighten 1-9/16 in. screws (BB) with
Phillips screwdriver (not included) into each
wall anchor (CC).
Hardware Used
CC
Wall Anchor
1-9/16 in. Screw
BB
2b. Acrylic and fiberglass installation: Place
fixed panel jamb (A) back into place. Tighten
1-9/16 in. screws (BB) with Phillips screwdriver
into each drilled hole.
Hardware Used
1-9/16 in. Screw
BB
1
2a
x 4
x 4
2b
x 4
A
CC
BB
A
BB
A