Technical Data
Rated Voltage ..................................................... 120 V ~ 60 Hz
Motor ............................................................................. 13 amp
No Load Speed ......................................................... 3000 rpm
Raking Width Max ............................................ 15 inch (38 cm)
Scarifying Depth
........................................... -0.4 inch – 0 inch
†
Raking Depth
................................................. 0 inch – 0.4 inch
†
Depth Adjustment .................................................... 5-position
Thatch Bag Capacity .......................................... 13.2 gal (50 L)
Dethatcher Cylinder ........................ 24 spring steel raking tines
1.5 mm thick + 1.2 inch (30 mm) long
Scarifier Cylinder ............................................ 26 slicing blades
Wheel Size ..................................................... 8 in. (20 cm) front
Net Weight ........................................................ 24.8 lbs (11 kg)
†
The negative scarifying/raking depth indicates that the tines/blades are raking
below the horizon (i.e. penetrating the soil layer).
Unpacking
Carton Contents
• Scarifier + dethatcher
• Handle knobs (6) and bolts (4)
• Adjusting gear wheels (2)
• Upper handle frame
• Middle handle bars (2)
• Lower handle bars (2)
• Thatch collection bag
• Cable clip
• Hex key wrench
• Scarifying cylinder (Pre-assembled)
• Dethatcher cylinder
• Manual and registration card
1. Carefully remove the electric scarifier + dethatcher and
check to see that all of the above items are supplied.
2. Inspect the product carefully to make sure no breakage or
damage occurred during shipping. If you find damaged or
missing parts, DO NOT return the unit to the store. Please
call the Snow Joe
+ Sun Joe
®
1-866-SNOWJOE (1-866-766-9563).
(-10 mm – 0 mm)
(0 mm – 10 mm)
5.1 inch (130 mm) long
4 in. (10 cm) rear
customer service center at
®
NOTE: Do not discard the shipping carton and packaging
material until you are ready to use the electric scarifier
+ dethatcher. The packaging is made of recyclable
materials. Properly dispose of these materials in
accordance with local regulations or save the packaging
for long-term product storage.
IMPORTANT! The equipment and packaging material are
not toys. Do not let children play with plastic bags, foils,
or small parts. These items can be swallowed and pose a
suffocation risk!
Assembly
m
WARNING!
Do not connect the scarifier + dethatcher to
the power supply until assembly is complete. Failure to comply
could result in accidental starting and severe personal injury.
Always wear gloves during assembly.
Connecting the Handle Bars
1. Insert the lower handle bars into the adjusting gear
wheels. Pay attention to the direction of the bars. The
space between the two bars at the bottom should be
wider than the top part (Fig. 1).
2. Make sure the holes of lower handle bars and adjusting
gear wheels are aligned. Insert the bolts on the machine
into these holes. Secure with a set of handle knobs
(Fig. 2).
7
Fig. 1
Narrower
space
Middle handle
bars
Wider space
Adjusting gear
wheels