General Information; General Description - Sima CEL-30 Manual De Instrucciones Original

1. GENERAL INFORMATION

WARNING: Pease read and understand perfectly the present instruction before using the machine.
SIMA S.A. thanks you for your trust in our products and for purchasing the ELECTRICAL SHEAR model CEL.
This manual p rovides y ou with the n ecessary in structions to s tart, use, maintain a nd in y our ca se, r epair o f t he
present machine. All asp ects as far as the safety and h ealth of the u sers is con cerned have been stated. Respecting
all instructions and recommendations guarantees safety and low maintenance. As such, reading this manual carefully
is compulsory for any person responsible for the use, maintenance or repair of this machine.
It is recommended to have always this manual in an easily accessible place where the machine is being
used.

2. GENERAL DESCRIPTION

SIMA S.A., ELECTRICAL SHEAR model CEL, have been designed and manufactured to be used in work sites to
cut steel reinforced and flat bars for construction, using interchangeable blades, mounted onto the cutting jaws.
Any other use of the machine is considered inadequate and can cause danger. Therefore, it is expressively
prohibited.
The manual shear model CEL has b een designed a nd manufactured to cut f lat and reinforced steel bars used
•
for construction and passi ve steel armatures for structur al concrete by means of two interchangeable blades
mounted onto the cutting jaw.
• The cu tting operat ion i s don e man ually by push ing the b ar on the roller , dropping th e bar into the cutting
throat, lowering the protection guard and pressing the pedal.
The CEL models are furnished with a ring to elevate the machine.
•
• The machine i s eq uipped w ith wh eels and handlebars to facilitate their movement a nd tran sport fo r sho rt
distances.
The internal mechanical components that are subject to wearing have been treated thermally to guaranty
•
their long durability and high performance.
The main body of the machine is a mono-block made of cast iron.
•
Cutting is performed by means a pedal or a handlebar.
•
• The blades are rectangular with four cutting faces.
Internal mechanisms are bathed in oil.
•
The frame of the machine is painted in oven with a highly resistance, anti-corrosion epoxy polyester paint.
•
The electrical equipment of the machine complies with the EC safety norms.
•
AUTEK MAQUINARIA 5392 7077
AUTEK MAQUINARIA 5392 7077