Setting Up; Switching On And Off; Preselecting The Rotation Speed; Setting The Milling Depth - Parkside POF 1200 D3 Manual Del Usuario

Setting up

Switching on and off
Switching on:
♦ Press the safety lock-out
♦ Press the ON/OFF switch
chine is running, you can release the safety
lock-out .
Switching off:
♦ Release the ON/OFF switch

Preselecting the rotation speed

♦ Set the required speed using the adjusting
wheel for speed preselection
1–2 = low speed
3–4 = average speed
5–7 = high speed

Setting the milling depth

♦ Make sure that the clamping lever
If it is released, turn it anticlockwise until it is
locked.
♦ Place the appliance onto the workpiece.
♦ Rotate the step stop
lowest position (0 mm).
The depth stop is now in line with the lowest
position (0 mm).
♦ Undo the locking screw
♦ Release the clamping lever
clockwise and pushing the appliance down-
wards until the milling machine is touching the
surface of the workpiece.
♦ Lock the clamping lever
lockwise.
│ GB │ MT
■ 50
and hold it down.
. Once the ma-
.
.
is locked.
until it engages in the
.
by turning it
by turning it antic-
♦ Slide the depth stop
reaches the lowest position (0 mm) of the step
stop .
♦ Set the depth stop
depth, tighten the locking screw
♦ Now, release the clamping lever
the appliance again.
♦ Check the milling depth by means of a practical
test.

Re-adjusting the milling depth

♦ The milling depth can be readjusted using the
dial .
♦ Release the clamping lever
clockwise and pushing the appliance down-
wards until the depth stop
is reached.
♦ Lock the clamping lever
lockwise.
♦ Set the milling depth with the dial
♦ Release the clamping lever
clockwise and raise the appliance again. Check
the milling depth by means of another practical
test.
Setting the milling depth with the
step stop
NOTE
► The step stop can be used for greater
milling depths in several stages with less chip
removal.
♦ Set the desired milling depth to the lowest step
(0 mm) of the step stop
ve).
♦ Then set the higher levels for the first machining
steps.
♦ Check the milling depth by means of a practical
test.
downwards until it
to the desired milling
.
and raise
by turning it
on the step stop
by turning it antic-
.
by turning it
(as described abo-
POF 1200 D3