Draining The Water - Honeywell DH45W Manual Del Propietário

USE & OPERATION (CONTINUED)

DRAINING THE WATER

WARNING: Always drain and discard water collected from dehumidification.
The water is not clean and cannot be used for drinking.
1. Draining water collected in the Water Tank
The condensed water can be collected directly into the water tank. When the water tank is full, the
dehumidifier will automatically shut OFF and
beeping sound.
IMPORTANT: Do not move the dehumidifier when the water tank is full as it will be heavy and can
cause water spillage.
1.1 Locate the water tank at the front of the dehumidifier.
Gently pull the water tank out and place it on the
floor. Two stands located at the bottom of the water
tank will automatically extend to help balance the
tank on the floor.
1.2 Grip the handle inside the water tank and carry the
water tank to a sink to empty.
1.3 Replace the empty water tank back into the front
of the dehumidifier. Please make sure that the tank
is properly positioned. The safety feature ensures
that any misalignment of the tank and the unit will
prevent the unit from turning back on.
IMPORTANT: Improper alignment or positioning of the water tank will cause the unit to pause
operation, the warning light on top of the dehumidifier will illuminate followed by a beeping sound,
until the water tank is fitted properly.
NOTE: There is a Float (without polyfoam) inside the water tank that senses the water level to
automatically stop dehumidification when the water tank is full. Make sure the Float is positioned
correctly inside the water tank by ensuring it lies level with the top edge of the water tank.
*Applicable for models DH45WGN / DH45WKN / DH45PWKN / DH45PWGN / DH50W /
DH50PW / DH70W / DH70PW / DH70WKN / DH70WGN / DH70PWKN / DH70PWGN
EN
will illuminate on the control panel followed by a
Stands*
10
Water Tank Handle
Float
(without polyfoam)