Publicidad
Idiomas disponibles
Idiomas disponibles
EB0491-FP1000-10.13_Layout 1 31/10/2013 11:11 Page 8
Power Cord Storage
• The electrical power cable can be stored on
the rear of the product using the convenient
power cable hooks.
Dismantling the Ewbank
& Polisher with Vac
• Depress the release clip on the rear of the
bottom section of the machine (see page 5,
Fig. 1) and lift the main body of the machine
to remove it (see page 5, Fig.2).
• Remove the dust container from the front of
the machine by depressing the metallic button
and pulling back on the handle to free the dust
container (see page 7, Fig. 10).
• Depress the steel button, then pull the handle
section to remove it (see page 7, Fig.11).
Cleaning the floor pads
• All pads and floor attachments are washable.
• The brushes and scouring pads can be washed
under the tap with warm water. The blue buffing
pads can be machine washed on a cool cycle
(85° F).
• The vacuum and polishing units are not
suitable for washing in water, they must be
wiped with a damp cloth.
Technical Data
Power
Voltage
Current
Frequency
Rpm
Vacuum
Floor Scrubber
®
1000W
120V~
8.5A
60Hz
2100
18 kPa
Cleaning and Maintenance
Cleaning the filters
• With the dust container removed, you will
have easy access to the filter and the filter
holder. The blue cyclone cone can also be
removed once the hinged bottom flap of the
dust container is open, and the dust container
empty.
• All these components are washable under the
tap – please take care as they are fragile.
• Once clean, the components must be left to
dry naturally. Please ensure that these parts
are completely dry before reassembling the
machine.
Troubleshooting
• Loss of vacuum suction?
- Check dust container is emptied.
- Check dust filter is clean.
• Smeary marks are made on floor when
polishing
- Has the polish/wax been allowed to dry?
- Does old polish/wax need to be removed?
• No gloss sheen is being produced
- Floor wax level may need to be increased, try
another coat. Allow to dry and re-polish.
- However, some types of floor do not produce
gloss finish.
• Scratches are made on the floor
- Check for grit or dirt stuck to the pads or
wheels.
- Clean/replace pads or clean wheels.
• Floor is too slippery
- Check the polish/wax is designed to be used
on floors. Floor polish / wax should produce
a glossy but grippy finish.
8
Publicidad
