Product Description - IRIS ID100 Manual De Instrucciones

Ocultar thumbs

Contenido

página de 17

/ 17
Contenido
Tabla de contenido
Marcadores

Tabla de contenido

Idiomas disponibles

991c/01

991e/01

991a/01

For information regarding device placement, coverage and method of installation, refer to

the established standard regulations and codes relating to automatic fire-detection systems.

Iris series detectors are compliant with EN54-7: Smoke detectors – Point detectors using the

scattered light principle, light transmission or ionization (ID100 and ID300 models only)

and EN54-5: Heat detectors – point detectors (for ID200 and ID300 models only).

Iris series detectors offer wide-spectrum detection of smoke particles generated by the majority of fires. They

are suitable for most applications and provide first-rate early warning.

The EITK-DRV driver, supplied by INIM Electronics, allows you to change the operating parameters to suit specific

environment conditions. This device permits easy programming and verification of contamination and

performance. For further details, refer to "Using the EITK-DRV driver" section.

During standby status, these detectors have low current draw, 80 A. However, in the event of alarm the current

draw increases to a maximum of 40mA thus signalling the condition to the control panel.

INIM Electronics offers three Iris series conventional fire-detectors, which can be identified by the technical

specifications/serial number on the back of the detector.

Optical detector equipped with a reference chamber based on the scattered light

principle (Tyndall effect). This detector must be installed in draught and obstacle

free place which guarantees appropriate air-flow into the reference chamber.

The detector will trigger an alarm when the level of smoke inside the reference

chamber reaches the following values:

• 0.08 dB/m (mode set via the EITK-DRV)

• 0.10 dB/m (mode set via the EITK-DRV)

• 0.12 dB/m (pre-set mode)

• 0.15 dB/m (mode set via the EITK-DRV)

Heat detector with heat-sensitive element capable of sensing the temperature

within the protected environment.

The operating modes, programmable via the EITK-DRV are:

• "A1R" (pre-set); the detector signals alarm status when the temperature within the protected

environment exceeds 58 °C or when the temperature undergoes anomalous changes.

• "B"; the detector signals alarm status when the temperature within the protected

environment exceeds 72°C.

• "A2S"; the detector signals alarm status when the temperature within in the protected

environment exceeds 58°C.

• "BR"; the detector signals alarm status when the temperature within the protected

environment exceeds 72° or when it senses a rapid temperature rise.

The operating modes of the "A2S" and "BR" are not certified.

Optical-heat detector with heat sensitive element and optical smoke chamber. The

combination of values provides (in accordance with the operating mode selected

via the EITK-DRV driver) high immunity to nuisance alarms and an exceptionally

sensitive detector which is capable of swift response to fires characterized by low

smoke emission.

The operating modes, programmable via the EITK-DRV driver are:

• "PLUS" (pre-set); the detector signals alarm status when smoke in the protected

environment exceeds the programmed threshold (programmed as described for the

ID100 model) or when the temperature within the protected environment exceeds the

Iris

Conventional fire detectors

ID100 - optical smoke detector

ID200 - temperature detector

ID300 - multicriteria detector