Descargar Imprimir esta página

Klimatronic Monsun 2.500 Manual Del Usuario página 12

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 15
without minerals) to ensure the functionality of the appliance. Do not exceed the max. amount of water.
Please reinsert the lid and connect the appliance to the power supply. Press the button "Power" to switch
on the appliance.
You may rotate the direction of the inner mist outlet on the lid by 360° as you wish. The outer mist outlet
is fixed to the lid and not movable.
Mist levels:
You can use the "+" and "-" buttons to select between three mist levels, which are indicated by
o
the LED light ring on the control panel:
LED lighting:
During operation, the LED lighting colour inside the water tank is changed automatically. The
o
lighting of the water tank and the lighting ring can be switched off by pressing the "LED" button
on the control panel and can be switched on again pressing "LED" or the "+" and "-" buttons.
Aroma function:
If you want to use aroma oils, open the lid of the aroma oil container. Place a piece of non-
o
woven fabric in the container and wet it with an aroma oil of your choice. Alternatively, you can
put the oil directly into the aroma oil container, but not directly into the water tank. Please replace
or wash the fabric and aroma oil container with detergent and dry both before using a new
aroma oil.
If there is not enough water in the water tank, the LED light ring flashes for 60 seconds and then turns
off automatically. Press the "Power" button to switch off the unit, then disconnect it from the power
supply. Please refill the tank with water and reconnect the unit to the power supply.
Floater exchange:
If the mist release decreases after a longer use, it could be an indication for a defective floater.
o
If you notice signs of wear on the floater, please replace it by following the steps below.
Make sure that the appliance is turned off and then lift the lid and tube up (see fig.1).
o
Hold the lid firmly and turn the tube counterclockwise to separate lid and tube (see fig.2).
o
Exchange the floater with the exchange floater. Please make sure that the side with the label
o
„UP" points upwards (see fig.3).
Place the lid back onto the tube and turn the tube clockwise to reconnect both elements (see
o
fig.4).
Put the lid and tube back on the appliance.
o
Cleaning
Always disconnect the appliance from the power outlet and let it cool before cleaning. Never immerse
the appliance or its electrical components in water to prevent electric shocks.
Wipe over the exterior of the appliance with a soft wet cloth and then wipe dry with a dry cloth.
Please fill clean water into the water tank and use the cleaning brush to clean the oscillator at the bottom
of the water tank. Rinse the water tank and wipe all interior surfaces with a soft, dry cloth. The water
tank should be cleaned weekly.
Please do not use any aggressive and chemical cleaning agents or abrasive cleaning agents such as
steel wool.
Blue LED – High mist level
Green LED – Medium mist level
Red LED – Low mist level

Publicidad

loading