Silent Disarming; Intrusion Warning Signals - Prestige APS-25HT El Manual Del Propietario

Ocultar thumbs Ver también para APS-25HT:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

# Doors Unlock - Optional
NOTE: Anytime the system is disarmed, the unit will rearm automatically unless a door is
opened. This will occur regardless of the arming method selected.

SILENT DISARMING

1. As you approach the vehicle, press and hold the Unlock button on the keychain transmitter
for 2 seconds.
" Red dash mounted LED turns off.
If passive arming was selected during the installation, then the LED will
start flashing rapidly, indicating that the system is re-arming automati-
cally. Open any door to suspend the automatic arming.
" Parking Lights flash two times.
If the parking lights flashed three times, then the alarm was triggered in
your absence. Before turning the key on, examine the LED to identify
which zone was triggered.
" Siren will not sound.
If the siren sounds 4 chirps, then the alarm was triggered in your
absence. Before turning the key on, examine the LED and refer to the
INTRUSION WARNING SIGNALS section of this manual to identify which
zone was triggered.
# Doors Unlock - Optional
NOTE: Must be selected on during installation.

INTRUSION WARNING SIGNALS

This system will inform you if an intrusion attempt has occurred while you were away from
the vehicle. If an intrusion attempt has occurred, the siren will chirp 4 times and the parking
lights will flash 3 times when disarming the system. Enter the vehicle, and observe the red
dash mounted LED to identify which zone was triggered.
If the LED is flashing two times...pause...two times...pause...etc., then an intrusion attempt
was made to a hood or trunk pin switch that was added to the system, or to a light activated
entry point if the alarm was installed using the voltage sensing feature.
If the LED is flashing three times...pause...three times...pause...etc., then an intrusion at-
tempt was made through one of the vehicle's doors.
These intrusion warning indicators are stored in the system's memory and will only be
erased when the ignition key is turned on.
ELIMINATING THE NORMAL ARM / DISARM CHIRPS
As explained earlier in the manual, you can eliminate the chirps selectively any time you arm
or disarm the system simply by holding the ARM / DISARM button for two seconds. If you find
the normal arming and disarming chirps annoying, they can be turned off permanently,
eliminating the need to hold the ARM / DISARM button for two seconds. To do this,
1. Turn the ignition key on then off.
Page 4

Publicidad

Tabla de contenido
loading

Tabla de contenido