Prestige APS-25HT El Manual Del Propietario página 9

# Remote Car Starter
# Remote Window Closure
# Remote Garage Door Interface
To activate the optional accessory, press and hold button 2 on the keychain transmitter for
four seconds.
NOTE: Alternate channel 2 operation is controlled by pressing and releasing button 2 of the
transmitter two times in succession. Consult your installation center for options that
may have been connected to this channel.
ADDITIONAL REMOTE FUNCTION (CHANNEL 3)
This security system has an additional feature that can be connected to a number of
different optional accessories. Some of the more common uses for this channel are;
# Remote Trunk Release
# Remote Car Starter
# Remote Window Closure
# Remote Garage Door Interface
To activate the optional accessory, press and release button 3 on the keychain transmitter
for 1 second operation or press and hold for continued operation of this output.
ADDITIONAL REMOTE FUNCTION (CHANNEL 4)
Hi-Jack activation from the transmitter is possible if the receiver has been programmed for
this feature. Consult your installation center for information pertaining to this feature and
which transmitter button to be used to activate the Anti HiJack mode. Once programmed, to
activate the Anti-HiJack feature from the transmitter, anytime the ignition switch is in the on
position, press and hold the pre-programmed channel three transmitter button for one
second. This will initiate the Anti-HiJack mode. Confirmation of activation will be indicated by
the LED and Parking Lights turning on for 5 seconds.
ANTI HI-JACK MODE OPERATION
If this feature is selected on, every time you start the vehicle and close all doors, the Anti Hi-
Jack mode is enabled. This feature is automatic and no action is required by the operator.
While the ignition is on, and the vehicle is being operated, if a vehicle door is opened and
then closed, the Hi-Jack mode is initiated (See Start Timing Delay On The Last Page Of This
Manual). After the initiation delay, the unit will begin it's 4 stage trigger cycle ending with the
vehicle engine turning off.
The following is a description of the 4 stages of shut down:
Stage 1 This stage begins after the initial delay of 15 or 45 seconds, (See start time setting
noted on the last page of this manual). The LED beginning to flash for 15 seconds.
This initial flashing of the LED allows the operator, if Hi-Jack mode is inadvertently
triggered, the time to disable the Hi-Jack mode before the siren sounds. This is
accomplished by pressing the hidden Anti Hi-Jack override button.
Stage 2 For the next 30 seconds in 10 second intervals, the siren will emit a single chirp.
Page 9