Kohler Sonata K-9459 Guia De Instalacion página 4

Apply
Sealant
2. Grab Bar Installation
IMPORTANT: Access to the back of the module is required to install
the grab bar. The grab bar must be installed before the bath/shower
module is moved into place for installation.
- Carefully install the studs in the grab bar until the studs bottom in
handle. Back the studs out three turns. Failure to back the studs out
can cause damage to the grab bar surface.
- Apply a small amount of silicone sealant to each end of the grab bar
and install the grab bar through the shower wall.
- Apply a small amount of silicone sealant to the back of the large
washers. Install the washers over the grab bar studs.
CAUTION: Risk of product damage. Hold the stud in place with a
hex wrench when tightening the hex nut. If allowed to rotate, the stud
can dimple the grab bar surface.
- Apply a small amount of silicone sealant to the threads of the hex nuts
and studs. Install the large washers, lock washers and hex nuts on the
studs. Use a hex wrench to hold the stud in place while turning the hex
nuts to finger tight. While still holding the stud with the hex wrench,
tighten the hex nuts 1-1/4 more turns with the open end box wrench.
- Remove any excess sealant from the grab bar and the inside of the
shower module.
- The shower module can now be moved into place for installation.
B
1021774-2-
Lock Washer
Nut
Large Washer
Stud
Grab Bar
4
Shower Wall
Kohler Co.