Advanced Operation - Xtech XTS-810 Guia De Instalacion

3. Drill pilot holes and insert the corresponding screws on the wall, leaving
26.5in of space between the head and the wall surface.
4. Carefully slide the soundbar over the screws that have just been installed.
Note: Mounting hardware is not included.
Initial setup
1. The remote control battery is already installed from factory. Remove the
plastic tab from the battery to operate the remote control included with the
soundbar.
Note: Replace the battery if you notice that the remote stops working or its
range seems reduced.
2. Then proceed to connect the RCA to RCA right angle cable to connect both
ends of the soundbar.
V. USB, TF Auxiliary, Optical and Coaxial connections.
1. Insert one end of the supplied coaxial or optical digital cable into the
matching input jack on the back of the soundbar and the other end on the
device you wish to play audio from.
2. Next, insert the supplied 3.5mm to RCA cable into the auxiliary jack of the
soundbar, connect the other end of the cable to a TV equipped with an
RCA audio jack output.
3. Likewise, if you want to play music directly from a flash drive or memory card,
simply insert your storage device into the USB or SD™ port on the right side
of the unit.
4. Plug the supplied power adapter into the DC jack on the soundbar. Then plug
the AC cable into the wall outlet.
5. After making sure all connections are done correctly, power the soundbar by
pressing the ON/OFF button located on the unit.
VI. Advanced operation
Pairing the soundbar with your Bluetooth
Note: Before installing this product, please make sure your device is compatible
with Bluetooth .
®
1. Enable the Bluetooth feature on your audio device and set it to discover the
®
wireless soundbar.
2. Place your wireless device and the soundbar not more than one meter away
from each other.
device
®