Using Radio Microphones; Use Radio Microphones - TLS Range M 100 Manual De Instrucciones

Operation Manual
Audio OUT
A stereo system can be connected via the output Audio OUT.
Headphones
To listen to cassettes or CDs via headphones, the devices have a
headphone connection with a 6.3 mm jack plug. Put the jack plug on
the headphones into the socket with the crossed out loudspeaker
symbol to switch the integrated loudspeaker to mute.

Using Radio Microphones

The radio microphone transmits signals to the built-in receiver without
cables and wires. Depending on how they are made up, the high
frequency radio signals can also go through doors, walls and windows,
delivering clear and pure reception. The TLS transmission channel is
factory-set to channel F.
Switch the microphone on (ON). The operation display lights up.
Switch the microphone off after use (OFF).
The operation (ON) and battery display starts to flash when the
batteries start running down. At this point the batteries need
changing. Put a 9 volt battery into the battery holder on the
microphone using correct polarity (the + pole on the battery must
agree with the + symbol on the microphone).
Note: If the microphone is not working, check first whether the
TLS device is connected to the mains or whether the
microphone is switched on. Make sure that the battery in
the microphone is not running low. In addition please
check if the selected channel on the hand transmitter is the
same as the channel on the TLS device. If there is
distortion, check whether the volume on the audio source
is not set at too high a level. If so, turn the volume down.
Also make sure that the device or the microphone is not
positioned too close to fluorescent lamps.
Transmission errors during operation of the radio microphone
If any errors occur during operation of the microphone, the
transmission channel can be changed on the channel switch.
Status 11/03 31