Handheld Remote Control Assembly - Craftmade Colossus COL72 Guia De Instalacion

10. Handheld Remote Control Assembly.

IN ORDER TO USE THE HANDHELD REMOTE CONTROL,
PLEASE CONTINUE WITH SECTION 10 for remote control
assembly instructions. If you have already installed the
wall control but do not wish to use the handheld
remote control, please proceed to Section 11.
Gently pull on remote control cover to separate top
and bottom parts. [Refer to diagram 1.]
In order to use wall control as a handheld remote
control, cut each wire on wall control (that was not
previously used)--use wire cutters to cut off each
wire as close to the wall control as possible. [Refer to
diagram 2.]
Install one 12-volt battery (included) in wall control.
[Refer to diagram 2.]
As this fan is not coming with light kit, the dimmer
switch (labeled ON and D) has been pre-set to the
"OFF" position (D).
Align holes in wall control with posts located on
inside of TOP part of remote control cover and
press together firmly. Place wall control into
BOTTOM part of remote control cover, aligning
posts in top of remote control cover with post
holes in the bottom. [Refer to diagram 3.]
(NOTE: Make sure to align narrower ends of
remote control cover before closing.) Squeeze
top and bottom of remote control cover together
until you hear a click at each end, indicating that
the remote control cover has closed completely.
IMPORTANT: Store the handheld remote control
away from excess heat or humidity. To prevent
damage to handheld remote control, remove the
battery if remote control will not be used for long
periods.
diagram 1
dimmer
switch
diagram 2
post hole
remote control
cover, BOTTOM
diagram 3
page 9
remote
control
cover
(top)
(bottom)
wall control
wire
III IV
II V
VI
I
wire
wire
12V battery
hole
III IV
II V
VI
I
wall
remote control
control
cover, TOP
post