Selecting a spray profile
Setting the spray volume
♦
Turn the spray volume adjusting wheel
the desired position:
(–) = minimum spray volume
(+) = maximum spray volume
NOTE
►
We recommend starting at the minimum
setting.
Selecting a jet type
♦
Undo the union nut
♦
Turn the protruding parts of the nozzle head
so that they point to the desired symbol on the
spray unit
.
The appliance has the following settings:
▯ round jet
vertical flat jet
horizontal flat jet
♦
Re-tighten the union nut
Maintenance and cleaning
WARNING! Disconnect the mains
plug during breaks and while doing
maintenance work on the appliance.
ATTENTION!
►
Never immerse the paint spray gun
completely in solvent.
NOTE
►
Thorough cleaning after every use is very
important for safety and operation. Other-
wise, the needle could get blocked and
proper operation of the appliance cannot be
guaranteed.
■
Wear suitable gloves when cleaning.
■
After every use, squirt water through the
appliance.
PFS 400 A1
to
.
.
♦
To clean the spray unit
nozzles
and the spray holes inside, use the
supplied cleaning brush
or a cloth. Never use petrol, solvents or
cleansers which can damage plastic.
♦
For rust protection purposes, you can spray a
little sewing machine oil through the spray gun
after cleaning.
♦
Oil all moving parts from time to time.
♦
Do not use any silicon-based lubricants.
♦
Store the appliance only in dry interior rooms.
Cleaning/replacing the air filter
Check the air filter
regularly, otherwise malfunc-
tions may occur.
♦
Remove the screws
♦
Remove the air filter cover
♦
Remove the air filter
contamination.
♦
If necessary, shake out the air filter
clean it under running water. Leave the air
filter
to dry.
NOTE
►
If necessary, replace the air filter
replacement air filter
♦
Proceed in reverse order in order to reassemble
the appliance.
, nozzle head
,
, cleaning needle
from the air filter cover
.
and examine it for
and
with the
.
GB │ MT
│
43
.
■