M
aintenance and care
Empty Dirt Tank
the dirt tank needs to be emptied when
the dirt reaches the "full" line on the side
of the tank.
1. unplug cleaner from electrical outlet.
2. Remove the easy empty dirt tank from
the vacuum base by pushing the tank
release button.
3. hold the dirt tank over a garbage
container. press the bottom lid release
button on the back of the dirt tank to
empty dirt.
4. Mount the easy empty dirt tank back
on the vacuum base.
NOTE: The dirt tank may be
washed in warm water with a
mild detergent. Make sure it is
completely dry before replacing.
Cleaning the pre-motor filter and inner cyclone
use only genuine bissell replacement filters
in your bissell cleanView vacuum.
1. unplug the cleaner from electrical outlet.
2. a. Remove the easy empty dirt tank
and locate the pre-motor filter as
described on the previous page.
b. Remove the foam filter from the
filter tray. the filter tray is fixed in-
place, but may be removed for clean-
ing by unscrewing the tray. the foam
filter and tray may be hand washed
in warm water with a mild detergent,
if desired. Rinse well, then air dry
thoroughly before replacing the filter.
Make sure all components are
completely dry before replacing.
3. the inner cyclone may also be removed
for cleaning. With the bottom of easy
empty dirt tank open, reach up into the
dirt cup and grasp the cyclone. twist
the cyclone clockwise to unlock and
pull straight down to remove. the inner
cyclone and dirt cup may be wiped
clean with a damp cloth. Make sure all
parts are dry before replacing.
w w w . b i s s e l l . c o m
2.
3.
NOTICE:
do not place the dirt tank or other
product components in the
dishwasher. hand wash only.
WARNING:
do not operate cleaner with
damp or wet filters or without
all filters in place.
2a.
3.
8 0 0 . 2 3 7 . 7 6 9 1
2b.
Tip:
When replacing the
inner cyclone after
cleaning, open the
pre-motor filter lid to
help guide the inner
cyclone into the
grooves at the top
of the tank. twist
counterclockwise
to lock the inner
cyclone into place.
9