Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
10. Remote Control Operation.
LIGHT button - Tap once to turn light ON or OFF.
Liquid crystal display shows the amount of
brightness as a percentage. Holding the button
down for more than 2 seconds will cycle light
through brightness settings. When turning the
light back ON, light will return to the same
brightness setting it was on when light was last
turned OFF.
FAN button - cycles through 3 FAN SPEEDS and
then returns to the OFF setting.
11. Testing Your Fan.
It is recommended that you test fan before
finalizing installation. Restore power from
circuit box and light switch (if applicable). Test
fan speeds with the FAN button on the remote
control. Test the light ON/OFF function with
remote control. Test dimmer function by
holding down the LIGHT button for more than
2 seconds. (For more detailed information on
using remote control, see Section 10 above.)
If the remote control operates all of the
functions of the fan and light, battery has been
installed correctly. If fan and/or light do (does)
not function, please refer to "Troubleshooting"
section to solve any issues before contacting
Customer Service.
Turn fan completely off before moving the
reverse switch. Set reverse switch to recirculate
air depending on the season:
- LEFT position in summer (diagram 1)
- RIGHT position in winter (diagram 2)
A ceiling fan will allow you to raise your
thermostat setting in summer and lower your
thermostat setting in winter without feeling a
difference in your comfort.
Important: Reverse switch must be set either
completely to the LEFT or completely to the
RIGHT for fan to function. If the reverse switch
is set in the middle position (diagram 3), fan
will not operate.
light dimmer setting
diagram 1
diagram 2
page 9
fan setting
motor
housing
reverse switch
diagram 3
Publicidad
Capítulos
Tabla de contenido
