Intex PureSpa SB-H20 El Manual Del Propietario página 10

• Humidity is a natural side effect of indoor spa installation. The room shall be properly ventilated to allow
moisture to escape. Install a ventilating system to prevent excess condensation, moisture in the room.
Additional requirements for outdoor installation
• Spa owners may need to comply with local or states laws relating to childproof fencing, safety barriers,
lighting, and other safety requirements. Contact your local building code enforcement office for further
details.
• Make sure the surface is level, flat, smooth and strong enough to support the full weight of the filled spa.
• Do not setup the spa on grass or dirt, as this increases the amount of debris entering the spa, and
damage the spa floor.
Do not expose the spa to direct sunlight for extended period of time. Provide protection from the
•
sun such as sunshade, tent, awning or gazebo.
• It is possible to install and leave the spa outside at a temperature not lower than 4°C (39°F) provided the
water temperature inside the spa is higher than 4°C (39°F) and the water inside the circulation system,
pump, pipe are not frozen. Put a "temp barrier mat" between the spa floor and the ground to prevent heat
loss from the bottom of the spa and to provide better heat retention. Do not use the spa if the ambient or
water temperature is 4°C (39°F) or lower.
Setup the spa with at least 2 persons.
1. Move the entire package to the selected site. Do not drag the spa tub across the ground as this can
cause damage and leakage.
Open the carton carefully as this carton can be used to store the spa during long term storage or when
not in use.
2. Lay out all the parts on the ground and make sure all the parts are accounted for. For missing or
damaged parts contact the appropriate Intex Service Center listed in the separate "Authorized service
Centers" sheet.
Spa Control Panel Adjustment
1. Push the lever down to tilt up the control panel and flip up the panel cover (see drawing 1.1).
2. To stow the control panel back push the button located on the back inward while pushing the control
panel down (see drawing 1.2).
S AVE THESE INSTRUCTIONS
(347IO) SPA ENGLISH 7.5" X 10.3" PANTONE 295U 07/08/2020
SET UP (continued)
1 2
347
English
A
1.1
1.2
Page 10