Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

6. Open the water flow regulation valve and set the water to
a suitable flow for the task. Adjust the water flow during
operation as needed. Push the valve forward to reduce
the water flow, and pull the valve backward to increase the
water flow (Fig. 16).
Fig. 16
Reduce
Water flow
regulation
valve
Basic Cleaning Procedure
The device is intended for removal of dirt and grime from
outdoor surfaces. The device is suitable for wooden, stone or
composite material (WPC) surfaces. Do not use the device for
cleaning planted areas such as a lawn or flower bed.
1. Before cleaning, remove all the loose elements from the
surface.
2. Before starting, position the unit and make sure the
brushes are evenly placed on the surface to be cleaned
(Fig. 17).
Fig. 17
3. Start the appliance and adjust the water flow as needed.
Guide the brushes over the surface with light pressure.
4. If you need to change brush speed or cleaning direction
during operation, make sure to close the water flow
completely by pushing the water flow regulation valve
forward before making the change.
NOTE: Once the appliance is shut off and the battery is
removed, it will return to the default setting of fast brush
speed and forward direction.
5. When cleaning delicate surfaces such as wood, it's
Increase
6. The rotating brush is equipped with side bristle on one
Fig. 18
Side
bristle

Shutting Down

1. Push the water flow regulation valve forward to stop the
2. Turn off the water source. Disconnect the garden hose
3. Before storage, drain the remaining water from the
m
drain the remaining water.
Storage
m
frost-free location where the temperature will not fall below
32ºF (0ºC). FREEZE DAMAGE IS NOT COVERED BY THE
WARRANTY.
• Store the patio cleaner indoors in a dry, covered area
• Always empty water from all hoses, attachments and unit,
13
recommended to test the device on an inconspicuous
area. During cleaning, do not allow the appliance to
remain in one area for an extended time. Keep it moving.
NOTE: Always clean wooden surfaces in the direction of
the grain. Always clean along the floorboards or wooden
elements and down the slope.
NOTE: If the wood has previously been pre-treated, the
pre-treatment may be removed and cause an uneven
effect.
side, which is used for cleaning the bottom of walls and
steps. Walk slowly along the wall and guide the side
bristle to brush the area to be cleaned (Fig. 18).
water flow. Release the trigger. Remove the battery.
connection on the patio cleaner.
appliance. Turn the water flow regulation valve to open
the water flow completely, stand the device upright for a
while. The remaining water will drain from the nozzles.
NOTE: An incompletely drained appliance can be
damaged by frost.
WARNING!
Do not knock the housing on the ground to
CAUTION!
Always store your patio cleaner in a
where it is not subject to adverse weather conditions.
before storing.

Publicidad

Tabla de contenido
loading

Tabla de contenido