Worx LANDROID WR165 Instrucciones De Usuario página 26

5. One-Time Scheduler
If your yard is split into two areas by a fence, then the One-Time Scheduler function can be used to mow the second area that does not
contain the charging station. This feature eliminates the need for a separate charging station for each area. For instance, if you have a
fenced-in back yard, you would have a back yard area and a front yard area. Even though there are two separate areas, there will still
only be one boundary wire loop. The boundary wire will need to be configured similar to that of Fig. 1. Run the boundary wire underneath
the fence to connect the two boundaries, leaving no gap between the wires that connect each area (see Fig. 1 inset). Essentially, you are
implementing the same concept as you would when excluding off-limits areas as in section 5. (Exclude any off-limits areas, if needed). The
only difference is that the area is external rather than internal with respect to the boundary of the first area.
ng point
2
<2ft
Zone 1
Zone 1 starting point
Follow these instruction for mowing the area without the charging station:
A. Power on Landroid and place inside the mowing area.
B. Press quickly three times.
C. Rotate to select "Home Present? - NO". Short press
D. Select the work time by rotating
press, and then rotate
times. Short press to confirm.
E. Rotate to select
Follow these instruction for mowing the area with the charging station:
A. Power on Landroid and place inside the mowing area.
B. Press three times quickly.
C. Clockwise rotate
charging station is in the area or not) and short press to enter setting. Selected
word will be blinking and short press to confirm.
D. Next, rotate
border cut or not ) and short press. Selected word will be blinking and short
press to confirm. Then use the same method to complete" working time".
E. And then Clockwise rotate
mowing
26
Getting started
Fig. 1 Fig. 1
until "Working Time" is selected. Short
to select the pre-defined work
and short press. Landroid will start to mow.
to select "home present?-YES/NO" (Whether the
to select "ENABLE border cut-Yes/no" (whether to do
to select "Start" and short press to start
Second area
Main area
once to confirm.
No gap between
wires
One Time START PAGE One Time START PAGE
Home present? No Home present?
Working Time 30min Working Time
START START
1
2
Only for reference
Mon.11/30 15:33 One Time START PAGE
Home present?
Enable Border cut?
starting now
charging Working Time
58% START
Only for reference
2
One Time START PAGE One Time START PAGE
Home present? Yes Home present?
Enable Border cut? No Enable Border cut?
Working Time 30min Working Time
START
1
2
Only for reference
EN
No
30min
Yes
No
30min
1
Yes
No
30min
START