Firmware Updates - Worx LANDROID WR165 Instrucciones De Usuario

Maintenance
1. Getting back to work in the Spring
When it is time to re-start Landroid for the new season, please perform the following checks:
A. Update the time and date settings via the app.
B. If you notice signs of oxidation on the charging contacts of Landroid or the charging station, clean these with a fine grit sand paper.
C. Fully charge Landroid's battery before operating.

Firmware updates

Landroid is always improving and new software versions are made available for free. Always keep Landroid software updated to make
the most of your machine.
1. Over-the-Air (OTA) updates
If your Landroid is connected to your Wi-Fi network you can check for new software updates by opening the "Update" section in the
app. Please make sure your Landroid is under Wi-fi coverage when updating.
2. Check which software version you have
In order to see the software version number you have to navigate to the "Firmware Update" sub-menu of the app.
3. Manual updates
A. If your Landroid is not connected to your Wi-Fi network, you can still update it to the latest software version with a USB drive.
B. Check your account page via www.account.worxlandroid.com to see if there is a new firmware version released.
C. Download the latest software version.
D. Make sure the USB drive is formatted to FAT32.
E. Copy the downloaded software file to the USB drive.
F. Make sure Landroid is powered off.
G. Locate the USB port which is inside the battery door.
H. Insert the USB drive in the port.
I. Place the Landroid on the lawn again, inside the boundary wire.
J. Power on Landroid. The screen will display that the firmware is being updated. Do not remove the USB drive from the
mower until instructed to do so.
K. Once the upload is compete, the screen will display "Please remove the USB key".
L. Once the USB drive is removed, the mower will reboot, and if necessary, install any other updates that are part of the software
package. This process may take a few minutes. Once the update is complete, the screen will go to the PIN entry screen.
NOTE: Make sure Landroid is within the boundary when restarting Landroid.
30
EN