Removal From Window - Kenmore 580.73184 Manual Del Propietário

FRONT INSTALLATION
Install the front grille onto the cabinet as follows:
• Hook upper tabs of front grille into slots on the
cabinet top. (FIG. 17)
• Push front grille's tips toward the cabinet in order
to snap side tabs into the cabinet. (FIG. 17)
• Open the inlet grille. (FIG. 18)
• Install the screw (ITEM E) through the front grille.
(FIG. 18)
• Close inlet grille. (FIG.19)
Front Installation FIG. 17
,ITEM E
grille
Front Installation FIG. 18
Front Installation FIG. 19
B IF AIR CONDITIONER IS BLOCKED BY
STORM WINDOW FRAME
• If storm window presents interference, fasten a 2"
wide wood strip to the inner windowsill across the full
width of the sill. The wood stdp should be thick
enough to raise the height of the window sillso that
the unit can be installed without interference from the
the storm window frame. See FIG. 20.
Top of wood strip should be approximately 3/4"
higher than the storm window frame to help
condensation to drain properly to the outside.
• Install a second wood strip (approximately 6" long by
1V2"wide and same thickness as first strip) in the
center of the outer sill flush against the back of the
inner sill. Screw the L brackets into this stdp.
This will raise the L bracket as shown in FIG. 20.
1 1/2" min.
WOOD STRIP MOUNTED (38mm)
ON TOP OF INNER SILL CLE 3/4"NCE tARA T
INNER
SILL
WINDOW
FRAME
INSIDE
OUTER
SILL
OUTSIDE
FIG. 20
REMOVAL FROM WINDOW
• Turn offand unplug the air conditioner.
• Removethe front grille. See HOW TO REMOVETHE
FRONT GRILLE. Refer to page 13.
• Unscrew the side screws that you installed in Step 12.
• Slide the air conditioner out of the cabinet.
BE CAREFULNOT TO DROP IT. Hold onto it firmly the
whole way sliding it out. Once removed,set it safety out
of the way.
• Removethe L bracket from window frame and the sash
seal from between the windows.
• Unscrewthe side curtainsfrom the window frame. Fold
them back to the sides of the cabinet.
• Removescrews attachingcabinet to inner sill. Be careful
not to let cabinet fall once screws are removed.
• Removecabinet from windowopening.
• Placeair conditioner into cabinet. Reinstallside screws
and Front Gdrle.
• Place unit and all assembly hardware in air conditioner
shippingcarton, and store in clean, dry place.
• Air conditioners covered in this manual pose an
excessive weight hazard. Two or more people
are needed to move and install the unit.
To prevent injuryor strain, use proper liftingand
carrying techniques when moving unit.
• When handling the air conditioner,be careful to
avoid cuts from sharp metal fins on front and
rear coils.
• Make sure air conditioner does not fall during
removal.
-8-