Safety Information; Intended Use - Runpotec CW 800 E Instrucciones De Uso

INTRODUCTION
Thank you for purchasing this RUNPOTEC Capstan Winch CW 800 E. The-
se operating instructions provide information on safe use of the capstan
winch. Read the operating instructions carefully before starting up. If you
have any questions about the start-up, assembly, safety, use or malfunc-
tions, please call or e-mail your dealer or RUNPOTEC. You will find our con-
tact data on page 2.

SAFETY INFORMATION

 The capstan winch may only be operated by persons who have been
trained in its use.
 Always make sure that the capstan winch is in safe operating condition
before use.
 The capstan winch must not be used if damage to the device is
determined.
 The pulling rope and all parts connected to it, must meet the require-
ments stated in the Technical Specifications and must not exhibit
damage of any kind.
 The operating staff must use personal protective equipment in line with
the construction site assessment.
 Before starting work, remove any obstacles in the work area.
 The capstan winch must be fastened such that either the ground or the
system can safety absorb the tensile forces.
 The operator stands next to the winch, keeping a sufficient safety
distance and pulls the pulling rope, applying very little force, at a
90° angle to the pulling direction via the safety rope guide.
 During pulling, do not reach into the capstan or the wound infeed and
output side rope section.

INTENDED USE

 The RUNPOTEC capstan winch is designed ONLY for horizontal
cable pulling.
 Transportation of persons is forbidden!
 Any other than the described use represents unintended use.
 The service life of 4 years can be exceeded many times over with
corresponding care.
 Unintended use or modification of the machine invalidates the
statutory warranty liability of the machine manufacturer as well as
the product liability.
 RUNPOTEC recommends the use of Ø 10 mm polyester for the
pulling rope as this has the ideal wrap factor.
RUNPOTEC GmbH – Irlachstrasse 31 – A-5303 Thalgau
Tel.: +43-6235-20 335 – Fax: DW 35 – office@runpotec.com
ENGLISH
9 9 9