Installing The Filter; Connecting To The Power Supply; Function; Control Panel - asecos PURIFIAIR.620 Manual De Instrucciones

2.2. INSTALLING THE FILTER

2.3. CONNECTING TO THE POWER SUPPLY

3. FUNCTION

3.1. CONTROL PANEL

The filters are already installed and ready for use.
After installing the filter, remove the cable ties from the power cable and insert the plug into the outlet. After
the power supply is connected, the POWER symbol on the control panel will be illuminated red. The device
will then be in Standby mode.
CAUTION:
Observe the permitted power supply under the TECHNICAL DATA.
PM1.0
Switching on and o
After you press the button, a short ringtone will sound. The symbol will be illuminated green, and the device
will switch on in automatic mode. The AUTO symbol will be illuminated white.
Selecting a mode
When the device is switched on, press the "MODE" button to choose from one of the three set operating
modes:

Operating modes

Automatic mode

• The air purifier output is automatically set and adjusted based on the sensor data
• The AUTO symbol will be illuminated white when this mode is active
• The AUTO symbol will be illuminated at half brightness when the mode is deactivated
Turbo mode
• The cigarette symbols will be illuminated, and the device will switch to turbo mode.
• The cigarette symbol will be illuminated white when this mode is active.
Night mode
• The device light is reduced to half brightness
• The device works at a low level and is not controlled by sensors. The NIGHT symbol will be
illuminated white when this mode is active
If the timer is also selected, it will be set in the background. After the set time expires, the device will
automatically switch to Standby mode.

Manual mode

When the device is switched on, press the speed button to manually adjust the operating level. The motor
will not be controlled by the sensors.
LED air quality display
PM1.0
DE
EN
NL
FR
ES
15