Lcd Display; Power On/Off - HQ-Power VDPLTC Manual Del Usuario

4. Installation
• Functions:
1. With DMX512 input function
2. 38 pre-programmed patterns
3. Up to 4000 tubes can be connected to the controller
4. Auto mode scans all patterns automatically
5. RGB colour mixing, controlled by DMX (dimmer trough red, green and blue)
6. Adjustable strobe
7. Adjustable speed and interval time for most patterns
8. Auto save function, saves the last working mode for all patterns individually
9. Solid aluminium holders for wall fixing included.
• Instructions:
1. LCD DISPLAY: shows you all necessary information about working mode, parameters etc.
2. MODE: used to choose the desired working mode and patterns. The display shows another function every
time you push the button. Keep the button pressed if you want to browse faster through all possible modes.
(see further for the possible options to choose from)
3. SET UP: used to set the parameter (interval, speed, flash and tube quantity) of the selected mode or
pattern. Almost every pattern can have its own parameters. These parameters are saved for every pattern
individually.
4. UP: used to choose a higher value for the selected parameter.
5. DOWN: used to choose a lower value for the selected parameter.
6. POWER ON/OFF: to switch the controller on and off. The last working mode is saved when the controller is
switched of.
7. DMX IN: The 3-pin male XLR-connector receives instructions from any universal DMX-controller.
8. DMX OUT: The 3-pin female XLR-connector is used to connect the controller with the next unit in the DMX
chain.
9. OUTPUT: connect this cable to the first tube in the chain.
10. DC INPUT: to connect the supplied 12V / 500mA DC adapter to the controller.
• Data signal line:
• Use:
There are four function buttons on the controller:
1. MODE
2. SETUP
3. UP
4. DOWN
VDPLTC
Data line
1
2 B female signal
3 A male signal
2
Function
GND
VELLEMAN