Torin Big Red Jacks T23401 Manual Del Usuario página 4

SAFETY MARKINGS
WARNING!
1. Study, understand, and follow all instructions before operating this device.
2. Do not exceed rated capacity.
3. Use only on hard, level surfaces, with less than 3 degrees of slope.
4. Center load on mounting plate.
5. Mount and support only on areas of the engine as specified by the vehicle manufacturer.
6. Lock mounting plate rotating mechanism before applying a load.
7. Lock the wheels/casters before working on the engine.
8. Rotate the engine using the handle or device provided.
9. Assure load is centered and secured to mounting attachments.
10. Off-center loads may make the load and handle rotate in either direction when the rotational locking
device is released.
11. Release rotational locking devices slowly and carefully.
12. No alterations shall be made to this product.
13. Only attachments and/or adapters supplied by the manufacturer shall be used.
14. Never work directly under a supported load.
15. Do not use this product for any use other than the manufacturer specified usage.
16. Failure to heed these markings may result in personal injury and/or property damage.
ASSEMBLY
Use the exploded drawing as your guide to assembly. Lay all parts and assemblies out in front of you before
beginning. The following procedure is recommended:
All numbers in parenthesis () refer to the index number from the parts breakdown.
1. Familiarize yourself with Engine Stand.
2. Attach wheel (11) to rear support axle (10) with
washer (12), and cotter pin (13).
3. Attach caster (16) to crossbeam (15) with
washer (4)，spring washer (7) and nut (8).
4. Attach main post (9) and crossbeam (15) to
rear support axle (10) with bolt (14) and spring
washer (7).
4