Cafe CES700M El Manual Del Propietario página 32

Troubleshooting Tips ... Before you call for service
Problem
Sometimes the oven
takes longer to
preheat to the same
temperature
Display flashes
Unable to set cook
time or delay time
Oven racks are difficult
to slide
Drawer does not slide
smoothly or drags
Steam from the vent
Water remaining on
oven floor after Steam
Clean cycle
Oven will not steam
clean
Display prompts for
Probe Temperature
Drawer does not open
49-2000386 Rev. 2
Possible Cause
Cookware or food in oven.
Number of racks in oven.
Different cooking modes.
Power failure.
You forgot to enter a cooking mode first.
The shiny, silver-colored racks were
cleaned in a self-clean cycle.
The drawer is out of alignment.
Drawer is over-loaded or load is
unbalanced.
When using the ovens, it is normal to
see steam coming out of the oven vents.
As the number of racks or amount of
food being cooked increases, the amount
of visible steam will increase.
This is normal.
Display flashes HOT.
Oven controls improperly set.
Oven door is not closed.
This is reminding you to enter a probe
temperature after plugging in the probe.
Pushing near the left or right edge of the
drawer panel.
Blockage behind the drawer panel
preventing the drawer from being
pushed in.
Power cord interfering with the drawer.
What To Do
The cookware or food in the oven will cause the oven to
take longer to preheat. Remove items to reduce preheat
time.
Adding more racks to the oven will cause the oven to
take longer to preheat. Remove some racks.
The different cooking modes use different preheat methods
to heat the oven for the specific cooking mode. Some
modes will take longer than others (i.e. convection bake).
Reset the clock.
See the Options section
Apply a small amount of vegetable oil to a paper towel
and wipe the edges of the oven racks with the paper
towel. Do not spray with Pam
Fully extend the drawer and push it all the way in See
the Care and cleaning of the range section.
Reduce weight. Redistribute drawer contents.
This is normal.
Remove any remaining water with a dry cloth or sponge.
Allow the oven to cool to room temperature and reset the
controls.
See the Using Steam Clean section.
Make sure you close the door to start steam clean cycle.
Enter a probe temperature.
Push on the center of the drawer panel.
Remove any item that is blocking the drawer from sliding
back.
Pull the oven forward. Position the power cord to leave
clearance for the rear of the storage drawer.
® or other lubricant sprays.
31