Pressure Washer Rinsing; Automatic Cool Down System (Thermal Relief) - Craftsman 580.752710 Instrucciones De Uso

Ocultar thumbs Ver también para 580.752710:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Pressure Washer Rinsing

After detergent is applied, scour the surface and rinse
it clean as follows:
1. Apply trigger lock to spray gun.
2. Make sure both chemical shut-off valves are in
"Off" position.
3. Remove black ProjectPro™ cleaning detergent
nozzle from nozzle extension.
4. Select and install desired ProjectPro™ nozzle, as
described in "How to Use ProjectPro™ Nozzle
System".
5. Keep spray gun a safe distance from spray
surface.
WARNING
High pressure spray could cause you to fall
if you are too close to the cleaning surface.
• Keep spray nozzle between 8 to 24 inches away from
cleaning surface.
• Operate this unit on a stable surface.
• Be extremely careful if you must use the pressure
washer from a ladder, scaffolding or any other relatively
unstable location.
• Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury if gun kicks back.
6. Apply a high pressure spray to a small area and
then check the surface for damage. If no damage,
proceed to step 7.
7. Start at top of area to be rinsed, working down
with same overlapping strokes used for cleaning.
How to Use the Hose Reel
Your cleaning system is equipped with a hose reel
designed to store the hose when unit is not in use.
See "Prepare Unit for Storage" for long term storage of
more than 30 days.
After each use:
1. Disconnect hose from spray gun and high
pressure outlet on pump.
2. Drain water from hose.
3. Slide one end of hose into hole on hose reel. Turn
hose reel with handle to coil hose onto reel.
IMPORTANT: DO NOT use your cleaning system with
the hose coiled onto the hose reel. The hose reel is for
storage purposes only.
Automatic Cool Down System
(Thermal Relief)
If you run the engine on your pressure washer for
3-5 minutes without pressing the trigger on the spray
gun, circulating water in the pump can reach
temperatures above 125°F. The system engages to
cool the pump by discharging the warm water onto
the ground.
14

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido