Technical Specifications; Repair And Maintenance - THOMSON DP7200 Manual De Instrucciones

PORTABLE DVD PLAYER
• Playback Mode: NTSC/PAL
• Disc mode: DVD,VCD, CD, MP3, CD-R, CD-RW, JPEG, DVD+ -R/W, MPEG4,
• Resolution: = 500 lines
• Video S/N: = 65dB
• Frequency response in 96KHz fs: 20Hz-20KHz: ± 1 dB
• Audio S/N: 90dB
• Dynamic range: 80dB
• Distortion: < 0.01%
• Converter N/A: 96KHz/24bit
• Video outlet: 1Vp-p (75 Ω)
• 2.0 Outlet channels
• Power consumption: 12W
• Voltage: DC IN 12V
Note: Unit design and specifications are subject to change without notice. The manufacturer reserves the right to make the
necessary improvements.
Consult the following table if there is a problem with the appliance.
Problems
Picture without sound • Check that the audio connectors are
connected properly.
• Check that the audio connectors are
not damaged.
• Check that the volume is high in the
VOL/CH section.
• Check that the audio parameters have
been correctly defined for the player.
• Check that the audio parameters have
been set up correctly for your television
set.
• Check that the sound has not been
turned off.
No sound, no picture • Check that ON/OFF is set to ON.
• Check that the plug is plugged in
correctly.
• Check that the electrical cable's plug
has been plugged into the mains socket.
• Check that the indicator light (LED)
is lit up.
DP7200

TECHNICAL SPECIFICATIONS

REPAIR AND MAINTENANCE

Solutions
The remote control does
not work
"No disk" is displayed
Problems Solutions
• Check that the
remote control's
battery is working.
• Point the remote
control towards the
player's infrared
sensor.
• Remove the
obstacles between the
remote control and the
player.
• Make sure that you
have inserted a disk in
the player.
• Check that the disk
has been inserted
correctly.
• Check that the disk
is not deformed, dirty
or scratched.
25 EN