Troubleshooting Guide - Craftsman CMCS714 Manual De Instructiones

can return it within 90 days from the date of purchase with
a receipt for a full refund – no questions asked.
lATin AMERiCA: This warranty does not apply to products
sold in Latin America. For products sold in Latin America,
see country specific warranty information contained in
the packaging, call the local company or see website for
warranty information.
FREE WARning lABEl REPlACEMEnT: If your warning
labels become illegible or are missing, call 1-888-331-4569
for a free replacement.
BE SURE TO FOLLOW SAFETY RULES AND INSTRUCTIONS
TROUBlE!
Saw will not start
Saw makes unsatisfactory cuts
CUTLINE worklight is flashing
Machine vibrates excessively
Does not make accurate miter cuts
Material pinches blade

TROUBLESHOOTING GUIDE

WhAT's WROng?
Battery not installed.
Battery not charged.
Brushes worn out.
Dull blade.
Blade mounted backwards.
Gum or pitch on blade.
Incorrect blade for work being done.
Battery not charged.
Saw not mounted securely to stand
or work bench.
Stand or bench on uneven floor.
Damaged saw blade.
Miter scale not adjusted correctly.
Blade is not square to fence.
Blade is not perpendicular to table.
Workpiece moving.
Kerf plate worn or damaged.
Cutting bowed material.
WhAT TO DO
Install battery. Refer to Installing and Removing the Battery Pack.
Charge battery. Refer to Charging a Battery.
Have brushes replaced by authorized service center.
Replace blade. Refer to Changing or Installing a New Saw Blade.
Turn blade around. Refer to Changing or Installing a New Saw Blade.
Remove blade and clean with coarse steel wool and turpentine or
household oven cleaner.
Change the blade type. Refer to Saw Blades under Optional Accessories.
Charge battery. Refer to Charging a Battery.
Tighten all mounting hardware. Refer to Bench Mounting.
Reposition on flat level surface. Refer to Familiarization.
Replace blade. Refer to Changing or Installing a New Saw Blade.
Check and adjust. Refer to Miter Control under Features and Controls.
Check and adjust. Refer to Miter Control under Features and Controls.
Check and adjust fence. Refer to Bevel Square to Table Adjustment
under Adjustments.
Clamp workpiece securely to fence or glue 120 grit sandpaper to fence with
rubber cement.
Take to authorized service center.
Refer to Bowed Material under Special Cuts.
English
21