Worx BladeRunner X2 WX572L Manual De Instrucciones página 12

14. MAINTAIN TOOLS WITH CARE. Keep
tools sharp and clean for best and safest
performance. Follow instructions for
lubricating and changing accessories.
15. DISCONNECT TOOLS before servicing;
when changing accessories, such as
blades, bits, cutters, and the like.
16. REDUCE THE RISK OF
UNINTENTIONAL STARTING. Make
sure switch is in off position before
plugging in.
17. USE RECOMMENDED ACCESSORIES.
Consult the owner's manual for
recommended accessories. The use of
improper accessories may cause risk of
injury to persons.
18. NEVER STAND ON TOOL. Serious injury
could occur if the tool is tipped or if the
cutting tool is unintentionally contacted.
19. CHECK DAMAGED PARTS. Before
further use of the tool, a guard or other
part that is damaged should be carefully
checked to determine that it will operate
properly and perform its intended function
– check for alignment of moving parts,
12
binding of moving parts, breakage of parts,
mounting, and any other conditions that
may affect its operation. A guard or other
part that is damaged should be properly
repaired or replaced.
20. DIRECTION OF FEED. Feed work into a
blade or cutter against the direction of the
blade or cutter only.
21. NEVER LEAVE TOOL RUNNING
UNATTENDED. TURN POWER OFF.
Don't leave tool until it comes to a
complete stop.
BladeRunner X2
®
Table 1
Minimum guage for cord
Volts
Ampere
Rating
120V 25ft
Not
More
More
Than
Than
0 6
6 10
10 12
12 16
ADDITIONAL SAFETY
WARNING FOR ALL SAWS
DANGER: Coasting Cutting Tool Can Be
Dangerous – Apply brake immediately to stop
cutting tool when the switch is turned off.
WARNING: The torque developed
during braking may loosen the blade-
retaining nut check periodically and tighten if
necessary, especially after braking.
ADDITIONAL SAFETY
WARNINGS FOR YOUR
BLADERUNNER
1. For your own safety read instruction
manual before operating saw.
a) Wear eye protection.
b) Keep hands out of path of saw blade.
c) Do not operate saw without guards in
place.
d) Do not perform any operation freehand.
e) Never reach around saw blade.
f) Turn off tool and wait for saw blade to stop
before moving workpiece or changing
settings.
g) Disconnect power before changing blade
or servicing.
SAVE THESE INSTRUCTIONS
Total length of cord in feet
50ft 100ft 150ft
AWG
18 16 16 14
18 16
14 12
16 16
14 12
14 12
Not Recommended
X2
®
EN