Publicidad
Idiomas disponibles
Idiomas disponibles
GB
Fitting and Recoding Instructions
Flush Fitting
1.
Using the bolt and keep as a template
mark the screw positions. Drill pilot holes
for the screws. (Use 3.5mm drill bit).
Use the security screw provided and
2.
firmly screw into position. (Note these
security screws cannot be undone).
Recess Fitting (Where required)
After fitting the bolt use it to position
3.
the keep plate. Mark it's position and
recess it into the frame.
4.
Drill the pilot holes as in 1. above and,
using the security screws, secure the
keep plate.
How to recode
Remove screw before
recoding
0
0
0 0
1.
The bolt is factory set on 0000. Before
you can recode the CombiBolt4 you need
to remove the screw marked in the
diagram above.
Hilton Cross Business Park, Cannock Road, Featherstone, Wolverhampton, WV10 7QZ
E-Mail: info@henry-squire.co.uk
Combi-Bolt 4
Henry Squire & Sons Limited
Tel: 01902 308050
TM
TM
2.
Once the screw has been removed draw the
bolt back to its stop position. Lift the bolt
knob and draw back to a second stop
position. Push it down to lock it in this
recoding position.
3.
Carefully rotate the coding wheels to the
desired number, taking care to align them to
the coding mark.
(Make a note of the new
code number).
Without moving the wheels reverse the
procedure of 1. The new code is now set.
4.
Put the security screw back.
Remember
On external installations always lock the
bolt even in the open position (This will
prevent unauthorised recoding).
Fax: 01902 308051
Website: www.squirelocks.co.uk
? ? ?
?
Publicidad
