Water Connections - lamber LV84 Guía De Instalación Y Utilization

WATER CONNECTIONS

Water installation must have the following
characteristics:
Temperature: °C
10÷12
Dynamic Pressure :
2 ÷ 4 bar (200÷400 kPa)
1) Connect the end of drain pipe "S" (fig.3 -
pag.38) th the drainage shaft.
Drain pipe should have slump to allow the
matters drain; under floor drain pipes should
have a dia. of 80-100 mm.
2) Connect inlet pipe "E" (fig.3 - pag.38) to a 3/4" screwed Gas tap .
Make sure there are no throttlings along the
pipe.
The National and Regional Standards existing
on the subject must be rigorously respected.
26