Care And Maintenance; Belt Adjustment - Energetics POWER RUN 4.5 Manual Del Usuario

Care and Maintenance

The home exerciser should not be used or stored in a moist area because of possible corrosion.
-
Check at least every 4 weeks that all connecting elements are tightly fitted and in good condition.
-
In case of repair please ask your dealer for advice.
-
Replace defective components immediately and/or keep the equipment out of use until repair.
-
Only use original spare parts for repair.
-
After exercising, immediately wipe off the sweat; perspiration can ruin the appearance and proper
-
function of the Home Exerciser.
Use a damp cloth to clean the Home Exerciser. Never use abrasives or solvents to clean the Home
-
Exerciser. To prevent damage to the computer, keep liquids away and keep it out of direct sunlight.
Inspect and tighten all parts of the treadmill regularly. Replace any worn parts immediately.
-

BELT ADJUSTMENT:

Do not overtighten the walking belt. This may cause reduced motor performance and excessive roller wears
To center the walking belt:
Place treadmill on a level surface
-
Run treadmill at approximately 5KPH
-
If the belt has drifted to the right, turn the right adjusting bolt 1/2 turn clockwise and the left adjusting bolt
-
1/2 turn counterclockwise See pic A
If the belt has drifted to the left, turn the left adjusting bolt 1/2 turn clockwise and the right adjusting bolt
-
1/2 turn clockwise and the right adjusting bolt 1/2 turn counterclockwise See pic B
Picture A If the belts has drifted to the LEFT
Warning: Always unplug the treadmill from the electrical outlet before cleaning or servicing the unit
cleaning.
General cleaning or the unit will greatly prolong the treadmill. Keep treadmill clean by dusting regularly.
Be sure to clean the exposed part of the deck on either side of the walking belt and also the side rails. This reduces
the build up of foreign material underneath the walking belt.
The top of the belt may be cleaned with a wet, soapy cloth. Be careful to keep liquid away from inside the
motorized treadmill frame or from underneath the belt.
Warning： ： ： ： Always unplug the treadmill from the electrical outlet before removing the motor cover.
At least once a year remove the motor cover and vacuum under the motor cover. Be careful not to interfere with
any of the wires or circuits.
PIC A
PIC B
Picture B if the belts has drifted to the RIGHT
7