Product Specific Applications; Limitations - Guardian Halo Big Block SRL Manual De Instrucciones

Product Specific Applications

! WARNING
Personal Fall Arrest: Halo Series SRLs may be used in Personal Fall Arrest applications as a
component of a MAXIMUM 1 Personal Fall Arrest System (PFAS). Structure must withstand loads
applied in the directions permitted by the system of at least 5,000 lbs. No free fall is permitted.
SRL must always be positioned at or above harness dorsal D-ring AND at or below anchor point.
Applicable D-ring: Dorsal.
Restraint: Halo Series SRLs may be used in Restraint applications. Restraint systems prevent
workers from reaching the leading edge of a fall hazard. Always account for fully deployed length
of lanyard/SRL. Structure must withstand loads applied in the directions permitted by the system
of at least 1,000 lbs. No free fall is permitted. Restraint systems may only be used on surfaces
with slopes up to 4/12 (vertical/horizontal). Applicable D-rings: Dorsal, Chest, Side, Shoulder.
Permitted weight capacity varies based on regulation. For all applications, worker weight capacity
range (including all clothing, tools, and equipment) is as follows:
• OSHA: 100-310 lbs.

Limitations

Fall Clearance: There must be
sufficient clearance below the
anchorage connector to arrest
a fall before the user strikes
the ground or an obstruction.
When calculating fall clearance,
account for a MINIMUM 2'
safety factor, deceleration
distance, user height, length
of lanyard/SRL, harness stretch,
and all other applicable factors.
Diagram shown is an example
fall clearance calculation ONLY.
Swing Falls: Prior to installation
or use, make considerations for
eliminating or minimizing all
swing fall hazards. Swing falls
occur when the anchor is not
directly above the location
where a fall occurs. Always
work as close to in line with
the anchor point as possible.
Swing falls significantly increase
the likelihood of serious injury
or death in the event of a fall.
Use of equipment in unintended applications may result in serious
injury or death. Maximum 1 attachment per connection point.
• ANSI: 130-310 lbs.
Fall clearance calculation shown
based on standing worker falling
directly in-line with anchor point.
Always consider potential swing
fall and other hazards when
calculating fall clearance.
• CSA: 100-310 lbs.
2'
2