Publicidad
Idiomas disponibles
Idiomas disponibles
TIMING
As a result of the new EU65 "Energy label" and
EU66 " Ecodesign" regulations issued by the Eu-
ropean Commission, which came into force as
from January 1st, 2015 , our products have been
adapted to comply with these new re quirements.
All of the models complying with the energy label
requirements, are equipped with new electronics
including a timer device for suction speeds con-
trol, when the air capacity exceeds 650m³/h.
Internal motor models, with maximum air capacity
higher than 650m³/h, are equipped with a timer de-
vice that automatically switches the suction speed
from 4th to 3rd speed, after 5 minutes operation.
If the appliance is working at 3rd speed, it is auto-
matically switched to 2nd speed, after 7 minutes
operation. Operation speeds can also be changed
during operation.
The energy consumption of the appliance in stand
– by mode is lower than 0.5W.
MAINTENANCE
* An accurate maintenance guarantees good fun-
ctioning and long-lasting performance.
* Particular care is due to the grease filter panel.
It can be removed by pushing its special handle
toward the back-side of the cooker hood and tur-
ning the filter downwards so to unfasten it from its
slot (Fig. 3A).
To insert the filter just perform the opposite ope-
ration.
After 30 hours working (model SIL-Module luxury
version), the push button control panel will signal
the saturation of the grease filter by lighting all the
buttons.
In the SILTC models (Touch Control Version) the
grease filter saturation is signalled by the flashing
of the two central push buttons (Fig. 16C). Press
the timer button to reset
The grease filter needs cleaning by regular hand-
washing or in dishwasher every two months at le-
ast or depending on its use.
* To clean the appliance itself tepid water and
neutral detergent are recommended, while abrasi-
ve products should be avoided. For steel applian-
ces specialized detergents are recommended
(please follow the instructions indicated o the pro-
duct itself to obtain the desired results).
Substitution of the LED bar:
Using an appropriate tool, remove the LED bar
from its seat (refer to Fig. 9), disconnect it electro-
nically using the appropriate con nector then sub-
stitute it with a LED bar with same characteristics.
18
.
Publicidad
