Headphone Functions - LEXIBOOK Star Wars BTHP500SW Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 11

HEADPHONE FUNCTIONS

Volume
To decrease the volume, press the – button (4). To increase the volume, press
the + button (3).
CAUTION: Too high volume, especially when using headphones, can damage
your hearing. For this reason, please turn the volume down.
Previous/ Next
Press and hold the – button (4) for one second to go back to the previous
track. Press and hold the + button (3) for one second to go to the next track.
Play
Press the Play/Pause button (2) to play audio files from your player.
Auto play/pause in Bluetooth ® mode
1. When you take off the headphone for more than 3 seconds, the music
enters pause mode.
2. The music resumes when you put the headphone back on within 5 minutes.
3. After 5 minutes, the headphone enters sleep mode and the Bluetooth ®
connection stops.
4. When you put the headphone back on during sleep mode, the headphone
reconnects to the last paired device. You can play the music again by pressing
the Play button.
Notes: Some music players do not fully support Bluetooth ® audio controls.
Play/pause, previous and next buttons on the Bluetooth ® speaker may
not respond. The music player may also turn off. To get the best control
experience in the said player, use the on-screen track controls of your music
player rather than those on the headphone.
Handsfree mode for phone calls
1. To answer calls, press
(2) once.
2. To reject a call, press and hold
for 2 seconds.
3. To hang up, press
once.
Microphone
The headphone is equipped with a microphone (6) that you can use for your
calls.
LED Status
- LED (7) lights up red when headphone is charging and turn off when
charging is complete.
- Darth Vader eyes flash when searching device/pairing and flash twice every
3 seconds when the headphone is paired.
- Darth Vader eyes light up for 2 seconds during power on/off.
- Darth Vader eyes blink three times every 15 seconds when the battery is low.
Connecting to an audio player (without Bluetooth ® )
1. Connect the 3.5mm audio cable to the headphone's 3.5mm jack and the
other end of the cable to your personal device.
2. Turn the headphone on.
3. Click on your device's play button to listen to your desired audio file.
4. You can also listen to audio files from Internet.
5. To turn the headphone off, press and hold the power button for 2 sec.
6. Unplug the cable from the headphone and the playing device.
Note: Play/Pause, Volume +, Volume - buttons on the headphone may not
respond. To get the best control experience in the said player, use the controls
of your music player rather than those on the headphone.
8

Publicidad

Tabla de contenido
loading

Tabla de contenido