After Installing The Hob, Make Sure That; Before Locating The Fixing Brackets; Adjusting The Bracket Position - EAS ELECTRIC EMIH900-FX Manual

If the hob is installed above an oven, the oven has a built-in cooling fan.
•
The installation will comply with all clearance requirements and applicable
•
standards and regulations.
A suitable isolating switch providing full disconnection from the mains
•
power supply is incorporated in the permanent wiring, mounted and
positioned to comply with the local wiring rules and regulations.
The isolating switch must be of an approved type and provide a 3 mm air
•
gap contact separation in all poles (or in all active [phase] conductors if the
local wiring rules allow for this variation of the requirements).
The isolating switch will be easily accessible to the customer with the hob
•
installed.
You consult local building authorities and by-laws if in doubt regarding
•
installation.
You use heat-resistant and easy-to-clean finishes (such as ceramic tiles)
•
for the wall surfaces surrounding the hob.

9.3 After installing the hob, make sure that

The power supply cable is not accessible through cupboard doors or
•
drawers.
There is adequate flow of fresh air from outside the cabinetry to the base of
•
the hob.
If the hob is installed above a drawer or cupboard space, a thermal
•
protection barrier is installed below the base of the hob.
•
The isolating switch is easily accessible by the customer.

9.4 Before locating the fixing brackets

The unit should be placed on a stable, smooth surface (use the packaging). Do
not apply force onto the controls protruding from the hob.

9.5 Adjusting the bracket position

Fix the hob on the work surface by screw 2 brackets on the bottom of hob(see
picture) after installation.
33
V.1