Speed Control; Ec Declaration Of Conformity - Proxxon NG 2/S Manual De Instrucciones

2. Mains connected. Red LED lamp 2 indica-
tes standby.
3. Connect the electrical appliance to the
Power Supply Unit. Socket 1 has a safety
mechanism preventing damage if it were
to be poled incorrectly.
4. Disconnect from mains after use.
Note:
Electrical appliances should not be used
continuously for more than 15 minutes. If
overloaded the Power Supply Unit will
switch off automatically. If this occurs,
switch off the Power Supply Unit (dis-
connect from mains). Leave to cool down
for approximately 3 to 5 minutes after which
the Power Supply Unit is ready for use
again. See points 1-4 above.

Speed Control

The NG 2/E Power Supply Unit has a speed
control feature via the control knob 5.
Turning it anticlockwise to the stop =
slowest speed. Turning it clockwise to the
stop = fastest speed.
If the electrical device begins to stall / stut-
ter during slow speed operation, either
increase the speed slightly or increase the
load on the device: The thyristor control
functions more effectively at higher current
levels.
If using the NG 2/E Power Supply Unit with
an electrical appliance, which likewise is thy-
ristor regulated, it must be set to maximum.
The correct speed should then be set on the
electrical appliance itself.
Disposal:
Please do not dispose of the device in
domestic waste! The device contains valua-
ble substances that can be recycled. If you
have any questions about this, please
contact your local waste management enter-
prise or other corresponding municipal facili-
ties.

EC Declaration of Conformity

Name and address of the manufacturer:
PROXXON S.A.
6-10, Härebierg
L-6868 Wecker
Product designation:
Article No.:
In sole responsibility, we declare that
this product conforms to the following
directives and normative documents:
EU Low Voltage
Directive
EU EMC Directive
Date: 25.11.2013
Dipl.-Ing. Jörg Wagner
PROXXON S.A.
Machine Safety Department
Power supply
units NG 2/S and
NG 2/E
28706 (NG2/S),
28707 (NG2/E)
2006/95/EC
2004/108/EC
- 7 -