Philips DailyDuo FC6161/63 Manual De Instrucciones página 8

English
8
3 Place the upper stick part on the lower stick part ('click') (Fig. 3).
Note: You only have to do this once. Never disassemble the upper stick from the lower stick.
4 Fasten the screw with a screwdriver or coin.
5 Place the stick on the floor nozzle ('click') (Fig. 4).
preparing for use
Charging the batteries
It takes approx. 7 hours to fully charge the batteries.
1 Put the adapter of the charging base in the wall socket.
2 Place the handheld vacuum cleaner in the stick ('click') (Fig. 5).
Note: Make sure the handheld vacuum cleaner is switched off when you place it in the stick.
3 Place the appliance on the charging base (Fig. 6).
The charging light goes on to indicate that the appliance is charging. (Fig. 7)
,
Note: The charging light does not give any information about the battery charge level.
When the batteries are fully charged, the charging process stops and the charging light goes
,
out to save energy.
Note: You can leave the appliance on the charging base, even when the batteries are fully charged. Every
5 minutes, the charging light lights up for 3 seconds. This indicates that the charging base checks if the
batteries are still fully charged.
Note: If you place the appliance on the charging base while it is switched on, the appliance switches
off automatically after 2 seconds and the batteries do not charge.
saving energy
If you are not going to use the appliance for a longer period of time, remove the adapter from the
wall socket to save energy.
using the appliance
The power of this cordless stick vacuum cleaner cannot be compared with that of a full-size
standard vacuum cleaner. Its cleaning performance on soft floors may not entirely match that of a
standard vacuum cleaner, but its cleaning performance on hard floors is just as good.
using the stick
You can use the stick to clean floors and carpets.
When you use the stick, always make sure the dust compartment is attached to the handheld
vacuum cleaner, to prevent damage to the handheld vacuum cleaner.
1 Place the handheld vacuum cleaner properly in the stick ('click'). (Fig. 5)
2 Press the on/off button on the stick to switch on the appliance (Fig. 8).
The appliance starts to operate at normal speed. Use this speed for optimal operating
,
time and minimal noise. The operating time at this speed is more than 20 minutes.
- Press the MAX button if you want to operate the appliance at maximum speed. Use this speed
for optimal cleaning performance. The operating time at this speed is 11 minutes (Fig. 9).
- If you want to switch back to normal speed, press the MAX button again.
Note: During use, the 'brush blocked' light may flash red to indicate that the roller brush is blocked. If this
happens, you have to remove the item that is blocking the brush or clean the brush (see chapter 'Cleaning').